Filter
Top Products
MR-8HD/CD Supplementary manual
1) Connect the MR-8HD/CD to the CD-R/RW drive
using a USB cable.
2) While the MR-8HD/CD is stopped, press the
[MENU/ENTER] knob to enter the MENU mode.
The display now shows the first page of the
menu selection screen.
3) Use the [MENU/ENTER] knob to select
"USB HOST
" on the second page and press
the [MENU/ENTER] knob.
The display now shows the USB HOST menu
screen.
4) Use the [MENU/ENTER] knob to select
"CD Burn
" and press the [MENU/ENTER]
knob.
The display now shows the Burning mode
selection screen.
You can select between "Track at once" and
"Disk at once" (see the previous page).
<Note>:
If "Not Mounted" is shown when you
select "USB HOST " using the [MENU/ENTER]
knob in step 3) above, an external CD-R/RW
drive is not connected to the MR-8HD/CD cor-
rectly.
If you press the [MENU/ENTER] knob in the
above condition, the following message pops
up.
In such a case, check the USB cable connec-
tion while the MR-8HD/CD stops accessing to
the HDD drive or CD-R/RW drive. Then con-
firming that the display does not show "Not
Mounted", press the [MENU/ENTER] knob.
5) Use the [MENU/ENTER] knob to select the
desired burning mode and press the
[MENU/ENTER] knob.
The display now shows the screen for selecting
a stereo WAV file in the "2 MIX folder" of the
current song. In the screen example below, only
one stereo WAV file is stored.
<Note>:
When more than one stereo WAV file
is stored in the "2 MIX folder" (as shown in the
example below), you can use the [MENU/EN-
TER] knob to select a desired file for "CD Burn"
(The maximum number of displayed files in the
list is ten).
23