Fujitsu AH512 Laptop User Manual


 
Security functions
Conguring password protection in BIOS Setup Utility
Before using the various options for password protection in the BIOS Setup utility
to increase data security, please observe the following:
Make a note of the passwords and keep them in a safe place. If you forget your
supervisor password you will not be able to acce ss your notebook. Passwords are
not covered by your warra nty and a charge will be made for assistance.
Passwordprotection
Your password can be up to
eight characters long and contain letters and numbers.
No distinction is made be
tween uppercase and lowercase.
Protecting BIOS Setu p Utility (supervisor and user password)
If you have opened these operating instructions on the screen, we recommend that
you print out the following instructions. Because you cannot ca ll the instructions
onto the screen while you are setting up the password.
BIOSSetupUtility
You prevent unauthorised use of the BIOS Setup U tility with both the supe rvisor and the user
password. The supervisor password gives yo u access to all functions of the BIOS Setup
Utility, while the user password only provides some of the functions. You can only set a
user password if a supervisor password has already been assigned.
Please refer to the "Settings in BIOS Setup Utility" , Page 57 section for a
description of how to call up and operate the BIOS Setup Utility.
Setting supervisor and user password
Start the BIOS Setup Utility and go to the Security menu.
Select the Set Supervisor Password eld and press the Enter key.
With Enter new Password: you are asked to enter a password.
Enter the password and press the Enter key.
Conrm new Password requires you to conrm the passw ord.
Enter the password again and press the Enter key.
Changes have been saved is a conrmation that the new password has been saved.
To set the user password, select Set User Password and proceed exactly as
when conguring the supervisor password.
If you d o not want to change any other settings, you can exit BIOS Setup Utility.
In the Exit menu, select the option Save Changes & Exit.
Select Yes and press the Enter key.
PasswordSupervisorpasswordUserpassword
The notebook will be rebooted and the new password will come into effect. It will now be
necessary to rst enter your supervisor or user password in order to open the BIOS Setup Utili ty.
Please note that the user password only provides access to a few of the BIOS settings.
42 Fujitsu