Filter
Top Products
4-4 fi-4110CU Image Scanner Operator’s Guide
Clean the automatic document feeder through the following procedure (see the figure
on the next page for location):
1) Open the automatic document feeder by pulling it toward you while raising the
cover open lever.
2)
Clean the following components with a dry cloth or a cloth moistened with cleaner
F1 or isopropyl alcohol:
Pad Clean the pad downward (in arrow direction) with a cloth
moistened with cleaner F1 or isopropyl alcohol.
In this case, be careful not to catch the cloth in the pick arm
or spring.
Glass surface,
White sheet
surface
Clean these surfaces gently with a dry cloth.
Pick roller,
Facing roller,
Feed roller
Gently clean the surface of these rollers with a cloth
moistened with cleaner F1 or isopropyl alcohol, while
rotating the roller by fingers.
If many foreign matters stick to the roller, the roller
becomes slippery; therefore, thoroughly clean it.
Eject roller Clean the roller while rotating the roller with power on.
1.With power on, open the automatic document feeder by
pulling it toward you while raising the cover open lever.
(*1)
2.Pressing the two round buttons on the operator panel at
the same time causes the eject roller to rotate little by
little.
3.Gently clean the surface of the roller with a cloth
moistened with cleaner F1 or isopropyl alcohol, while
rotating the roller with the cloth pressed against the
surface of the roller. (As a guideline, the eject roller
rotates one revolution every seven presses.)
If many foreign matters stick to the roller, the roller
becomes slippery; therefore, thoroughly clean it.
*1: Be sure to open the automatic document feeder when the operator panel display
indicates other than “P” or “0”. While the display indicates “P” or “0”, the eject
roller does not rotate even if you press the round buttons.