Filter
Top Products
5
Warning Label
HOT warning label:
The glass surface inside the ADF becomes hot
during the operation. Be careful not to touch glass
surfaces inside the ADF.
To avoid burns, never touch around the area
indicated by this label.
Take care not to pinch your fingers while turning the ADF.
Safety Information
Warning Indications Used In This
Manual
The following indications are used in this manual to obviate
any change of accident or damage to you and/or the equip-
ment.
The following are important warnings described in this manual.
You must NOT remove this warning label from your
scanner. When it gets old or unreadable by stain-
ing or scratches, contact the store where you
purchased the scanner or an authorized FUJITSU
scanner service provider.
This indication alerts operators to an
operation that, if not strictly observed,
may result in severe injury or death.
This indication alerts operators to an
operation that, if not strictly observed,
may result in safety hazards to personnel
or damage to equipment.
A TRIANGLE symbol indicates that
special care and attention is required.
The drawing inside the triangle shows
the specific caution.
A CIRCLE with a diagonal line inside
shows action which users may not
perform.
The drawing inside or under the circle
shows the specific action that is not
allowed.
Outline characters on a colored
background show instructions users
should follow.
It may also include the drawing that
shows the specific instruction.
Do not damage the Power cable.
A damaged Power cable may cause fire or
electric shock. Do not place heavy objects on
Power cables, or pull, bend, twist, heat,
damage or modify Power cables.
Do not use damaged Power cables or power
plugs, or install any cables or power plugs to
loose wall sockets.
Use only specified Power cables and
interface cables.
Use only specified Power cables and interface
cables. Failure to use the correct cables might
cause electric shock and/or equipment failure.
Do not use the Power cable provided with the
scanner for other devices, since this might
cause equipment failure and other troubles or
an electric shock.