Filter
Top Products
3
4. Notes on Designing
■ Notes on designing printed circuit board for the user system
When the header board is connected to the user system, some part mounted around the NQPACK in
the user system may be contacting the header board if the height of the part is tall. To prevent this,
design the printed circuit board for the user system so that the components do not exceed the height
shown in Figure 2. Figure 2 shows the dimension figure of the header board.
Figure 2 Header Board Dimensions
㪈
㪉
㪈㪈㪐
㪈㪉㪇
㪚㪥㪉
㪈
㪉
㪈㪈㪐
㪈㪉㪇
㪚㪥㪈
㪚㪥㪊
㪬㪈
40.0 mm
30.0 mm
40.0 mm
Approximately
13.0 mm *
1
NQPACK052SB
:Tokyo Eletech Corporation
YQPACK052SB
:Tokyo Eletech Corporation
WR-120SB-VF-N1 : JAE *
2
PCW-1-1-1PW
:MAC EIGHT
WR-120SB-VF-N1 : JAE *
2
U1: User system I/F connector
CN3: Incorrect insertion prevention socket
CN1/CN2: MCU board I/F connector
*1 : The height differs slightly depending on how the YQPACK and NQPACK are engaged.
*2 : Japan Aviation Electronics Industry, Limited