Filter
Top Products
B – 2
(2) Activating the continuous operation test
Open the ADF and close it again. If no document is loaded on the ADF within five
seconds after closing the ADF cover, the image scanner runs in flatbed mode. If docu-
ments are loaded on the ADF within five seconds after closing the ADF cover, the image
scanner continuously feeds the document from ADF. Once the image scanner start
reading documents in the flatbed mode, it does not feed documents from ADF even if
documents are loaded on the ADF.
(3) Ending the test in flatbed mode
To stop the carrier movement in flatbed mode, open the ADF cover. If the ADF cover is
opened, the POWER lamp starts blinking immediately after the carrier returns to the
home position.
(4) Ending the test in ADF mode
If the ADF document hopper is empty, feeding documents from the ADF ends. To restart
feeding, open the ADF cover and close it again. Then load documents on the ADF docu-
ment hopper within five seconds after closing the ADF cover.
(5) LED status on error
If an error occurs during the test, the LED indicates as shown in table B.1.
If paper is jammed in the ADF, remove the jam and close the ADF. The CHECK lamp
stops blinking about three seconds after closing the ADF cover. To feed the document
from ADF, open and close the ADF.
Errors/Alarm
Paper jam
Carrier drive alarm
Optical system alarm
Motor fuse failure
Lamp fuse failure
READ lamp
Off
Off
Off
On
On
CHECK lamp
Blink
On
Blink
On
Blink
POWER lamp
On
Blink
Blink
Blink
Blink
Table B.1 LED at an error