Filter
Top Products
4-12 C141-E205
(2) SCSI connector and power supply connector
The connector for the SCSI bus is an unshielded SCA-2 connector conforming to SCSI-3 type
which has two 40-pin rows spaced 1.27 mm (0.05 inch) apart. The power connector is included in
the SCSI connector.
Figure 4.14 shows the SCSI connector. See Section B.1 in Appendix B for signal assignments on
the connector.
For details on the physical/electrical requirements of the interface signals, refer to Sections 1.3
“Physical Requirements” and Section 1.4 “Electrical Requirements” in the SCSI Physical Interface
Specifications.
Figure 4.14 SCA2 type 16-bit SCSI connector
(3) Connector for external operator panel
This connector is not available for NC model drives.