Filter
Top Products
C141-E219 IN-1
Index
A
AC noise filter ................................................ 4-8
actuator........................................................... 1-5
allowable input voltage and current................ 4-7
alternate area................................................... 3-9
alternate block allocation.............................. 3-10
alternate block allocation by FORMAT
UNIT command...................................... 3-11
alternate block allocation by REASSIGN
BLOCKS command................................ 3-12
alternate block allocation during
FORMAT UNIT command execution.... 3-11
alternate cylinder ............................................ 3-4
alternate spare area ......................................... 3-4
automatic alternate block allocation............. 3-13
automatic alternate block allocation at
read operation ......................................... 3-13
automatic alternate block allocation at
write operation........................................ 3-13
automatic alternate block reassignment.......... 1-3
B
basic operation test......................................... 6-4
BCRC ............................................................. 3-7
block address of user space ............................ 3-9
block descriptor.............................................. 5-5
C
cache feature................................................... 1-3
caching parameter........................................... 5-9
changing revision number in field.................. 6-8
checking at abnormal end............................... 5-5
checking initial operation ............................... 5-4
checking operation after installation and
preparing HDD for use ............................. 5-4
command queuing feature .............................. 1-3
compactness.................................................... 1-2
connection requirement .................................. 4-8
connector ........................................................ 4-8
continuous block processing........................... 1-2
control mode parameter.................................. 5-9
controller circuit ............................................. 1-5
current waveform ........................................... 4-7
cylinder configuration .................................... 3-1
D
data field......................................................... 3-7
data format...................................................... 3-1
data security at power failure..........................2-6
data space........................................................ 3-1
defect list.......................................................3-10
defect management.......................................3-10
defective block slipping..................................1-4
definition of sense data...................................7-3
delivery...........................................................5-2
diagnosis.........................................................1-4
diagnostic........................................................6-1
diagnostic test ...............................................6-10
diagnostics and maintenance ..........................6-1
dimension .......................................................4-1
disk ................................................................. 1-5
disk drive replacement....................................6-7
disk drive troubleshooting ............................6-13
disk read error.................................................7-4
dismounting drive......................................... 5-10
E
ECC ................................................................ 3-7
environmental magnetic field .........................4-6
environmental specification............................2-4
environmental temperature.............................4-5
environmental/power requirement..................2-4
error analysis...................................................7-1
error analysis information collection..............7-1
error information indicated with sense
data............................................................7-3
error rate ......................................................... 2-5
error recovery ................................................. 1-3
error recovery during self-diagnostic..............6-3
error recovery parameter ................................5-8
example of SAS system configuration............1-6
examples of mounting frame structure........... 4-3
F
factory maintenance........................................6-7
field maintenance............................................6-7
finding possibly faulty part........................... 6-14
format capacity ...............................................3-8
format of extended sense data.........................7-2
format parameter......................................5-5, 5-6
FORMAT UNIT command ............................ 5-6
formatting .......................................................5-5
function specification .....................................2-2
G
gap ..................................................................3-7
general description..........................................1-1