Filter
Top Products
Index
IN-2 C141-E219
general note.....................................................5-1
H
hardware function test.....................................6-2
hardware specification....................................2-1
hardware structure ..........................................1-5
head.................................................................1-5
high speed positioning....................................1-4
high-speed data transfer..................................1-2
I
indicating revision number .............................6-8
indicating revision number at factory
shipment....................................................6-8
initial diagnosis at time of power-on ..............5-4
initial seek operation check...........................6-10
initial self-diagnostic.......................................6-2
installation.......................................................5-1
installation requirement ..................................4-1
installation/removal/replacement....................5-2
interface connector (SAS plug) signal
allocation.................................................4-10
interface error .................................................7-4
interface test....................................................6-4
internal test space............................................3-3
L
large capacity..................................................1-4
leakage magnetic flux.....................................4-6
limitation of bottom-mounting .......................4-3
limitation of side-mounting ............................4-3
logical data block addressing..........................3-8
loop.................................................................6-4
low noise and low vibration............................1-4
low power consumption..................................1-4
M
maintenance level ...........................................6-7
maintenance requirement................................6-6
microcode downloading..................................1-5
MODE SELECT/MODE SELECT
EXTENDED command.............................5-5
model name and order number .......................2-1
mounting drive................................................5-3
mounting orientations.....................................4-2
mounting procedure........................................5-3
mounting requirement.....................................4-1
mounting screws must use M3 × 0.5
metric ........................................................4-3
MTBF .............................................................2-5
MTTR.............................................................2-6
N
noise filter .......................................................4-8
note on handling drive ....................................5-1
note on mounting............................................4-3
O
online self-diagnostic......................................6-3
operation check.............................................6-10
operation test.................................................6-10
outline of troubleshooting procedure............6-11
P
packaging........................................................5-2
PAD ................................................................3-7
page code = 1..................................................5-8
page code = 3..................................................5-5
page code = 7..................................................5-8
part replacement..............................................6-7
part that can be replaced in field.....................6-6
physical sector allocation................................3-5
PLO Sync........................................................3-7
port address.....................................................5-3
port addressing................................................1-6
positioning error rate.......................................2-5
power on/off sequence....................................4-7
power supply requirement ..............................4-7
precaution .......................................................6-5
preventive maintenance ..................................6-6
programmable data block length.....................1-3
programmable multi-segment data buffer.......1-2
R
random/sequential read test.............................6-4
read/write circuit.............................................1-5
read/write error recovery parameter................5-8
reliability.........................................................2-5
reporting result of self-diagnostic and
error indication..........................................6-3
reserve and release function............................1-3
responses to operation errors ..........................5-4
revision label...................................................6-7
revision number ..............................................6-7
S
SAS standard...................................................1-2
sector format...................................................3-6
seek test...........................................................6-2
self-diagnostic.................................................6-1
SEND DIAGNOSTIC command....................6-3
sense data........................................................7-1
1-1x-xx ....................................................7-4
3-0C-03.................................................... 7-4
3-1x-xx ....................................................7-4