Filter
Top Products
3.4 Connection Requirement
C156-E228-02EN 3-23
3.4.4 External operator panel settings (CNH2)
(1) Device type mode
Table 3.5 shows the device type settings which are returned when the INQUIRY
command is issued to the optical disk drive.
Table 3.5 Device type mode setting
Device Type CNH 2/Pin 9 - GND
X'07' (Optical memory device) Short
X'00' (Direct access device) Open *
* Setting when shipped
(2) Verify mode
The default setting of the verify function is specified. When the verify mode is
invalid, verification is not performed when the WRITE command is issued. With
the verification invalid, the writing speed is increased by about 20% (depending
on the situation). Table 3.6 shows the verify mode settings. The verification can
also be specified as valid or invalid by the MODE SELECT command.
Table 3.6 Write verify mode setting
Write verify mode CNH 2/Pin 11 - GND
Does not perform verification for the WRITE
command (invalid)
Short
Performs verification for the WRITE command
(valid).
Open*
* Setting when shipped
Data loss: When the verify function is invalid, the write data
quality is not guaranteed. This mode should not be used for storing
important data. When using the mode for storing important data, a
preventive system measure such as file duplication is required.