Filter
Top Products
Operation and Cleaning
5-4 C156-E228-02EN
If you insert an optical disk cartridge with the printed shutter facing
upward by pressing on the rear of cartridge at the left edge, you may
hear an audible click but the drive may not become READY. In
such a case, press the cartridge further by pressing on the back of the
cartridge from the center (somewhere near the notched section of the
panel front) until the LED indication lamp goes on. If this happens,
the cartridge has been normally inserted.
5.1.4 Removing an optical disk cartridge
Remove an optical disk cartridge as described below.
(1) While the drive is powered on:
1) Press the eject switch to remove an optical disk cartridge (see Figure 5.3).
Notes:
1. No optical disk cartridge can be removed if the SCSI command inhibits
ejection.
2. Remove an optical disk cartridge after it is completely ejected.
3. Be careful not to let a cartridge drop out of the drive when it is ejected. This
may happen depending on the ambient environment and the cartridge's
condition even if the drive installation conditions are met.
(2) While the drive is powered off:
While the drive is powered off, you cannot remove an optical disk cartridge by
pressing the eject switch.
To remove a cartridge in such a case, insert an accessory eject jig or a pin about 1
mm in diameter into the manual eject hole (see Figure 5.1) and push on it.
Notes:
1. NEVER eject a cartridge while the BUSY LED lamp is on. The data may be
destroyed or the drive may be damaged.
2. Note that a cartridge may drop out of the drive when it is ejected.
3. Do not carry the optical disk drive around while a cartridge is loaded in it.