Fujitsu MHU2100AT Computer Drive User Manual


 
Fujitsu Internal Use Only Index
C141-E202-01EN IN-5
STANDBY command ............................... 6-8
STANDBY IMMEDIATE ...............5-35, 6-9
STANDBY IMMEDIATE command........ 6-8
standby mode............................................. 6-8
start mode ................................................ 4-19
status........................................................ 5-55
status flag................................................. 5-49
status register........................................... 5-11
status report in the event of an error........6-20
subassemblies............................................ 4-2
surface temperature measurement
point....................................................... 3-6
sustained Ultra DMA data
in burst ............................................... 5-152
out burst ............................................. 5-157
system configuration ................................. 2-3
T
terminating an ultra DMA data in
burst ................................................... 5-137
terminating Ultra DMA data
out burst ............................................. 5-142
test span................................................... 5-57
the data
in transfer........................................... 5-136
out transfer......................................... 5-141
theory of device operation.........................4-1
timing..................................................... 5-146
total number of drive error ...................... 5-55
track following operation ........................ 4-18
track slip processing................................ 6-10
U
ultra DMA CRC rule ............................. 5-144
ultra DMA data
in command........................................5-135
out command......................................5-140
ultra DMA data burst timing
requirement ........................................5-149
ultra DMA data transfer.........................5-148
ultra DMA feature set ............................5-134
ultra DMA sender and recipient
timing requirement.............................5-151
ultra DMA termination with pull-up
or pull-down.......................................5-145
unrecoverable read error..........................1-11
using the read segment buffer..................6-15
V
VCM current sense resistor (CSR) ..........4-14
viterbi detection circuit ............................4-11
W
wide temperature range..............................1-2
WRITE BUFFER.....................................5-75
write cache....................................... 1-3, 6-19
write circuit................................................4-9
WRITE DMA ..........................................5-71
WRITE DMA EXT................................5-116
WRITE LOG EXT.................................5-120
WRITE LONG.........................................5-26
WRITE MULTIPLE................................5-65
WRITE MULTIPLE EXT .....................5-119
write precompensation...............................4-9
WRITE SECTOR(S)................................5-24
WRITE SECTOR(S) command
protocol ..............................................5-130
WRITE SECTOR(S) EXT.....................5-115
WRITE VERIFY .....................................5-27
write/read recovery ..................................4-17