Filter
Top Products
3
2. REPLACEMENT OF THERMAL
PA P E R
When the thermal paper runs out, the PAPER
LED blinks, printing stops automatically and
the audible alarm sounds for five seconds.
With 1 m of paper remaining, a red paper end
mark appears on the paper. When the red
mark appears, replace the thermal paper as
shown in the procedure below.
REQUIRED THERMAL PAPER
Type: TP0340 (112 mm × 40 m)
Code No.: 000-801-765
(One roll supplied.)
1. Press the [FEED/MARK] key to draw out
the remaining thermal paper.
2. Pull the thermal paper cover forward and
take out the paper spool.
3. Curve the leading edge of the new roll
paper to ensure smooth feeding, and set
the paper spool to the new roll paper.
Red mark
Reel
Thermal paper cover
Tape
Adhesive
Adhesive may
remain on the paper
after tape is removed.
This may cause a
paper jam, so cut
paper to remove
adhesive.
4. Insert the paper into the paper insertion
slot just above the paper container and
press the [FEED/MARK] key to feed out
the paper.
5. Set the paper in the paper container.
Confirm that
paper is fed out
through the slot.
Insertion slot
6. Press the [FEED/MARK] key to confirm
that the paper is properly aligned.
If the paper comes out with its edges
wrinkled, continue to press the
[FEED/MARK] key. Correct alignment will
be made automatically.
7. Close the thermal paper cover.
8. Press the [MODE] key to complete the
replacement of thermal paper. (The
PAPER LED goes off.)
Note: If the PP-505 receives data when there
is no paper it doesn’t print them out
after replacing the thermal paper.
Remedy for paper jam
If the paper is jammed cut it off at the front
panel and rewind it into the paper container.