Filter
Top Products
Using Your Gateway Flat Panel Monitor www.gateway.com
8
Starting the monitor
To start the monitor:
Important
The appearance of your monitor may
vary from that shown.
1 Press the power button on the front of monitor. The power LED on the
power button turns on.
2 Turn on your computer.
After your computer is running, the power LED on the monitor’s power
button should be blue. Allow about 10 seconds for the monitor image to
appear. If the power LED is not blue or you do not see a monitor image,
check the connections. For more troubleshooting information, see
“Troubleshooting” on page 18.
3 Adjust the tilt of the monitor for the best viewing angle.
Important
When adjusting the monitor settings,
always press the Auto button before
entering the OSD. This will automatically
adjust the monitor image to the ideal
settings for the current screen resolution.
4 After you see the Windows desktop, press the Auto button on the right
side of the monitor to automatically adjust your monitor image to the ideal
settings.
5 Use the on-screen display (OSD) to adjust other monitor settings. For more
information, see “Adjusting monitor settings” on page 9.
8511460.book Page 8 Thursday, April 6, 2006 2:32 PM