Filter
Top Products
Chapter 4: Troubleshooting
What type of cable do I need for the T1/E1 ports on a Gateway Series
appliance?
A straight-through RJ45 T1/E1 cable is needed for connecting to the RJ45
ports on a Gateway Series appliance when connecting to the PSTN. If
connecting to a TDM PBX, a crossover RJ45 T1/E1 cable may be
required. Use only shielded cables to ensure compliance with the
International EMC standards. The appropriate cables may be ordered
from Digium by visiting www.digium.com. Refer to Table A-2 on page
86 for pin assignments.
How can the Gateway Series software be reinitialized without
modifying any configuration settings?
The Gateway Series software can be reinitialized without modifying any
configuration settings by following the steps described below.
1. Press the reset switch once.
2. The status LED will flash amber for 5 seconds.
3. The status LED will flash red for 2 seconds, acknowledging the
reinitialization request.
4. The Gateway Series appliance will restart itself.
5. The status LED will turn green once the reinitialization is complete.
How can the Gateway Series GUI password be reset to its default
without modifying any configuration settings?
Digium, Inc. Page 81