Filter
Top Products
F-60+ Operation and Maintenance Manual
Operation
© GBC Pro-Tech 1999 April
3-1
The F-60+ Laminator has been designed with safety as
a primary consideration. However, you must become
thoroughly familiar with the controls, proper operation,
proper service procedures, and safety features of the
laminator before using or servicing the unit.
GBC Pro-Tech F-60+ Laminator is a powerful machine
that is designed to mount, laminate and encapsulate.
The forces required to accomplish these tasks can vary
from negligible to very large.
In addition, the laminating roll of the F-60+ can reach
temperatures of 270
°
F (132
°
C). At these temperatures
there is a danger of a severe burn if the roll is touched
during set-up, operation or servicing.
Safety is an important feature of the F-60+ Laminator.
It has emergency stop buttons and a photoelectric eye
system on the infeed.
The laminator is equipped with four emergency stop
buttons located on the top front and back of either side
of the laminator. Any of these, if engaged, stops the
laminator. To continue operation all emergency stop
buttons must be in the up position and you must press
the reset button above the fuse panel on the back of the
laminator (see Figure 3-2). The laminator is also
equipped with a power lockout (see Figure 3-3) which
stops power to the machine.
Figure 3-1: Using the Emergency Stop Buttons
Figure 3-2: Resetting the Laminator
Figure 3-3: Power Lockout
1
/
4
t
u
r
n
Twist pressed
button to resume
operation - the
button pops up
Push either
button to stop the
laminator
POWER
Reset Button
P
O
W
E
R
Insert
Lock
Circuit
Breakers
Secured in
"Off" Position