Filter
Top Products
GBC 1264WF/1244WF Operation Manual
© 2006 General Binding Corporation Page 29
Start Laminating
1. At this point you should have your laminator Webbed
with the appropriate material for your application.
2. The feed table should be in the normal operating
position.
3. Close the main and Pull roll nips. Rollers should be
closed.
4. Speed is set to 3 or less and front motor direction is
selected.
5. Press the start button.
6. Set main roller pressure at desired setting for
laminating by turning the roll lift handle.
CAUTION: If using PSA film, an air pocket may result
between the main rollers and pull rollers. Raise the pull
rollers to allow the air Pocket to pass.
7. Make any necessary film brake tension adjustments,
pull/main roller pressure, and clutch and/ or rewind
brake tension adjustments.
8. Position the item to be laminated on the feed table.
9. Align the leading edge of the item parallel to the heat
roller nip (Fig. 9).
10.With both hands and an outward force push the image
slower than the speed of the rollers into the nip of the
heat rollers (Fig. 10).
CAUTION: Avoid forcing the image into the main
roller nip as this action will cause the corners of the
leading edge to buckle and create a wave.
Fig. 9
Fig. 10