Filter
Top Products
Power Consumption
This USB Hub provides all four downstream ports with a total of 500mA. This
should be adequate for most mice, keyboards, and other low power devices.
Hardware Installation
1. Connect the series “A” connector (see Diagram A, Fig. 1, pg. 6) of the built-in
uplink cable into one of the downstream ports on your computer or another
hub.
2. Connect the series “A” connector of USB Device, such as a USB mouse, a
USB keyboard, and so on into any one of the downstream ports on the
USB Hub. (see Diagram B).
3. If your computer indicates the devices are not receiving sufficient power; or
if devices are not powering up, you may need to order an AC Power Supply
(see ordering instructions at the end of troubleshooting section).
4
97958IN 8/19/03 8:09 AM Page 5