Filter
Top Products
IR REMOTE CONFIGURATION
8
Setting the IR Remote Channel on the RMT-4IR
In the event that IR commands from other remote controls confl ict with the
supplied IR Remote Control Unit, changing the remote IR channel will fi x this
issue. The IR Remote Control Unit has a bank of DIP switches for setting the IR
channel.
The DIP Switch bank on the IR Remote Control Unit is located underneath the
battery cover.
1 2
1 2
1 2
1 2
Remote Channel 3:
Remote Channel 1:
Default
Remote Channel 2:
Remote Channel 4:
Left: Picture of the opened rear battery
compartment of the RMT-4IR remote showing
the exposed DIP Switch bank between the
battery chambers.
The IR channel selected on the IR Remote Control Unit must match the IR
channel assigned to the 4x1 3GSDI Switcher. For example, if you set both DIP
switches on the remote to the down position (IR channel 1), you must set the 4x1
3GSDI Switcher to use IR channel 1.
See page 9 on how to change the IR channel on the 4x1 3GSDI Switcher.