Filter
Top Products
21
RS-232 SERIAL CONTROL COMMANDS
2. USING SHORT-CUT CHARACTERS TO CHANGE SETTINGS
2.1 HYPERTERMINAL
tm
SETTINGS in Microsoft Windows
tm
First, please set up the correct communication confi guration by running these
commands (as shown on the screen shot immediately below):
File->Properties->Setting->ASCII Setup
Also, please be sure to unmark the check box that says “Send line ends with line
feeds.”
2.2 EXAMPLE -- CHANGE THE ROUTED SOURCE
Now you are ready to route Display input sources.
At the Hyperterminal cursor prompt, type the numeral key of the input to switch
to, followed by the ENTER key.
Wait until you see the message “Function Done” on the Display. At this point the
Display should show the correct Source corresponding to the numeral that was
typed.