Filter
Top Products
9
IR REMOTE CONFIGURATION
Setting the IR Remote Channel on the RMT-8IR
In the event that IR commands from other remote controls confl ict with the
supplied IR Remote Control Unit, changing the remote IR channel will fi x this
issue. The IR Remote Control Unit has a bank of DIP switches for setting the
Remote IR channel.
The DIP Switch bank is located underneath the battery cover.
1 2
1 2
1 2
1 2
Remote Channel 3:
Remote Channel 1:
Default
Remote Channel 2:
Remote Channel 4:
Left: Picture of the opened rear battery
compartment of the IR Remote Control
Unit showing the exposed DIP Switch bank
between the battery chambers.
The IR channel selected on the IR Remote Control unit must match the IR
channel assigned to the 2x4 Switcher for HDMI 1.3. For example, if you set both
DIP switches on the remote to the down position (IR channel 1), you must set the
2x4 Switcher for HDMI 1.3 to use IR channel 1.
Refer to page 10 on how to change the IR channel on the 2x4 Switcher for HDMI
1.3.