Filter
Top Products
GA-K8NF-9(rev. 2.2) Motherboard - 66 -
English
Figure 1
The BIOS Setup menus described in this section may not show the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Integrated Peripherals
On-Chip IDE Channel0 [Enabled]
On-Chip IDE Channel1 [Enabled]
IDE DMA transfer access [Enabled]
On-Chip MAC Lan [Auto]
On-Chip LAN BOOT ROM [Enabled]
NV IDE/SATA RAID function [Disabled]
NV Serial-ATA 1 [Enabled]
x NV SATA 1 Primary RAID Disabled
x NV SATA 1 Secondary RAID Disabled
NV Serial-ATA 2 [Enabled]
x NV SATA 2 Primary RAID Disabled
x NV SATA 2 Secondary RAID Disabled
IDE Prefetch Mode [Enabled]
USB Memory Type [SHADOW]
AC97 Audio [Auto]
Onboard 1394 [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
(2) Configuring SATA controller mode and boot sequence in BIOS Setup
You have to make sure whether the SATA controller is configured correctly in system BIOS Setup and
set BIOS boot sequence for the SATA hard drive(s).
Step 1:
Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). In the
example in Figure 1, make sure that NV Serial-ATA 1 or NV Serial-ATA 2 under the Integrated
Peripherals menu is enabled (NV Serial-ATA 1 controls the SATAII0_1 connectors and NV Serial-ATA
2 controls the SATAII2_3 connectors). If you want to create RAID, set the NV IDE/SATA RAID function
item to Enabled (Disabled by default) (Figure 1). Set the NV IDE/SATA RAID function item to
Disabled if you do not want to create RAID.