Filter
Top Products
ENGLISH-6
INSTALLATION
Installation of the Projector and Screen
CAUTION
• Install the projector in a suitable environment according to instructions of the
accompanying manual “SAFETY INSTRUCTIONS” and this manual.
• Use the liquid crystal projector at the horizontal position only.
If you use this projector by
the lens up position, the lens down position or the side up position, this may cause the heat
inside to build up and cause damage.
Be especially careful not to install it with ventilation
holes blocked.
Refer to the drawing and table below to determine the screen size and projection distance.
TOP VIEW
SIDE VIEW
a: Distance from the LCD projector to the screen.
The projection distance shown in the table below
are for full size (1024 x 768 dots) images.
Table 1. Installation Reference
Screen size
(inches)
a (inches)
Min. Max.
40 65 78
60 98 117
80 131 157
100 163 196
120 196 236
150 246 295
200 328 394
a
Angle Adjustment
Use the foot adjuster on the bottom of the projector to adjust the projection angle. It is variable
within 0˚ to 9˚ approximately.
1. Lift up the front side of the projector, and pressing
the foot adjuster button, adjust the projection angle.
2. Release the button to lock at the angle to be fixed.
3. Turn the rear foot adjuster to adjust the left-right slope.
CAUTION
Do not release the foot adjuster button unless the projector is being held; otherwise, the
projector could overturn or the fingers could get caught and cause personal injury.
Foot Adjuster
Press the foot adjuster button
Rear Foot Adjuster