Filter
Top Products
- 5 -
D-Sub socket, using a PC or notebook and the “BE-Flash” software. You can find
the current operating software for the
head-end station,
the software “BE-Flash”
and the current assembly instructions
on the website “www.gss.tv”.
The modules are designed exclusively for use in the STC 160 head-end station.
3 Installation
Caution
– Ensure the head end station is mounted so it will not be able to vibrate.
Avoid, for example, mounting the head end station onto a lift shaft or any
other wall or floor construction that vibrates in a similar way.
– Before installing or changing a module, switch off the head-end station
or unplug the power cable from the mains power socket.
Take precautions to prevent static discharge when working on the device!
•
Open the housing of the head-end station according to the instructions in the
STC 160 installation manual.
3.1 Installing the modulator module
– Always position modules which belong together next to each other. The
modulator module must be installed to the right of the digital module or
an add-on module.
– When installing a module, make sure that it is inserted in the long num-
bered grooves in front of the contact strip on the board at the rear wall
of the housing.
The shorter, not numbered grooves without contact strip on the board at
the rear wall of the housing are for add-on modules only.