Filter
Top Products
2
The Ultra Mouse comes with a NiMH battery pack already
installed, but you will need to remove the plastic tab located
inside the battery compartment. This clear plastic tab pre-
vents the battery from discharging until you are ready to use
your mouse. To remove the tab and charge your batteries:
1. Press the Battery Release button at the bottom of the
mouse and lift the NiMH battery pack off.
2. Remove and discard the plastic tab.
3. Replace the battery pack by snapping it into place on the
mouse.
4. Connect the power adapter to the charging cradle and
plug it into a power source.
5. Place the mouse in the charging cradle. The cradle’s LED
Indicator light, located at the bottom of the unit, will
turn solid green and the LED Indicator light on the
mouse will faintly flash green while its batteries are
charging.
6. Once the batteries are fully charged, the LED Indicator
light on the mouse will maintain a steady glow and will be
ready for use.
Battery Tips
For optimal battery life, avoid using the mouse on dark-
colored surfaces.
When the battery drops to twenty percent (20%) of its
full charge, the LED Indicator light on the mouse will blink
intermittently when in use. To optimize the performance
of your NiMH battery, it is best to recharge it after every
day of use.
If a full charge is not required, you can remove the mouse
from the charging cradle at anytime. You do not need to
wait for the LED Indicator light to stop flashing.
To conserve power, the mouse enters a “Sleep Mode”
when it is left on for more than 24 hours. To awake from
Sleep Mode, click any button.