Home Automation 37A00-1 Switch User Manual


  Open as PDF
of 5
 
HAI 15A RELAY SWITCH OPERATION
The HAI 15A Relay Switch has configurable items that can be set using the UPB™ UPStart configuration software. The following
describes the operation of the HAI 15A Relay Switch in its factory default configuration.
Local Rocker Switch Operation
The HAI 15A Relay Switch has a Decora-style rocker switch that can be used to control the load as follows.
Rocker Event Top Rocker Bottom Rocker
Single-Tap Load turns on. Load turns off.
Table 1 - HAI UPB™ 15A Relay Switch Local Operation
LED Indicator
The HAI UPB™ Wall Switch comes equipped with a multi-color LED indicator that is normally lit to blue when the load is off. The
LED is off when the load is on.
If used, the LED in the HAI Auxiliary Switch is always lit.
HAI AUXILIARY SWITCH OPERATION
The HAI UPB™ Wall Switch can be connected to one or more HAI Auxiliary Switches producing multi-way circuits. Each HAI
Auxiliary Switch has a Decora-style rocker switch that controls the load in the exact same manner as the Decora-style rocker switch
on the connected HAI UPB™ Wall Switch, as previously described. When connected, the LED remains continually on at all times
while power is applied.
Setup Mode
To configure the HAI UPB™ Wall Switch using an HAI controller or a PC running the UPB™ UPStart configuration software, it
must be put into Setup Mode as follows:
Step Operation
1 Tap the rocker switch quickly 5 times.
2 The HAI UPB™ Wall Switch will cycle the load one time and blink its LED blue to indicate that it is in Setup Mode.
Note: the switch will automatically exit Setup mode after 5 minutes.
Reset to Factory Default Settings
To reset the HAI UPB™ Wall Switch to factory default settings:
Step Operation
1 On the HAI UPB™ Wall Switch that you want to reset to factory default, tap the rocker switch quickly 5 times.
2 The HAI UPB™ Wall Switch will cycle the load one time and blink its LED blue to indicate that it is ready to be reset.
3 Tap the rocker switch quickly 10 times to reset to factory default setting.
4 The HAI UPB™ Wall Switch will cycle the load one time and blink its LED red to indicate that it has been reset.
5 Tap the rocker switch once more to stop the LED from blinking.
 previous