Home Automation 38A00-3 Switch User Manual


  Open as PDF
of 4
 
Changing Switch Color
The color of the HAI UPB™ Lumina Mode Controller may be changed to complement
the interior décor. The HAI UPB™ Lumina Mode Controller is supplied with a white
bezel. Additional colors are available; contact your HAI distributor for more
information. When changing the bezel, make sure that the HAI UPB™ Lumina Mode
Controller is disconnected from all power, and proceed as follows:
1. The bezel attaches to the HAI UPB™ Lumina Mode Controller with two small
Philips head screws: one on the upper-right corner and one on the lower-left corner
(Figure 2).
2. Using a small-bladed Philips screwdriver, unscrew each of the two screws.
Remove the bezel from the back housing.
3. Install the new bezel by aligning the mounting holes on the bezel with the
installation pins on the back housing. Secure bezel to back housing with the two
Phillips screws that were removed in Step 1.
INSTALLATION INSTRUCTIONS
1. Be sure that all power at the wall box has been disconnected by turning off the circuit breaker.
2. If applicable, remove the faceplate from the existing device, remove the existing device from the wall box, and disconnect the
wires from the existing device. Identify the “Line” (black) and "Neutral" (white) wires.
3. Remove ¾” of insulation from each of the wires on the HAI UPB™ Lumina Mode Controller. Install the HAI UPB™ Lumina
Mode Controller by connecting wires per wiring configuration shown in Figure 3.
4. After all connections have been made, be certain that all wire connectors are firmly attached and there is no exposed copper.
5. Gently place the wires and HAI UPB™ Lumina Mode Controller into the wall box with the “AWAY” pushbutton at the top of
device. Using the supplied screws, attach the HAI UPB™ Lumina Mode Controller to the wall box.
6. Before installing the faceplate, restore power to the circuit for testing.
7. After testing the HAI UPB™ Lumina Mode Controller for proper local operation, install a Decora-style faceplate over the HAI
UPB™ Lumina Mode Controller.
BLACK WHITE
LINE
NEUTRAL
38A00-3
CIRCUIT
MAIN
PANEL
BREAKER
120VAC
60Hz
LUMINA
MODE
CONTROLLER
AWAY
SLEEP
SPCL
HOME
PARTY
VAC
Figure 3 – Wiring Diagram
Figure 2 – Changing Switch Color
 previous next