Filter
Top Products
Setup Mode
To configure the HAI UPB™ Lumina Mode Controller using a Lumina keypad, it must be put into Setup Mode as follows:
Step Operation
1 Press and hold the “AWAY” and “HOME” pushbuttons simultaneously for at least 3 seconds.
2 All of the LED indicators will blink to indicate that the HAI UPB™ Lumina Mode Controller is in Setup Mode.
Configuring the HAI UPB™ Lumina Mode Controller from a Lumina Keypad
HAI UPB™ Lumina Mode Controllers reside on the 8th unit in any Room. Configure the HAI UPB™ Lumina Mode Controller on
the 8th unit in a Room as follows:
Step Operation
1 Put the HAI UPB™ Lumina Mode Controller into Setup Mode (as described above).
2 On the Lumina keypad, from the main menu or top-level display, press 6 (STATUS), and then press 1 (CTRL).
3 Enter the Unit Number of the HAI UPB™ Lumina Mode Controller followed by the ' # ' key, and then press ' # # '.
4 The display will provide you with step-by-step configuration status. When complete, the display shows “COMPLETED”.
Reset to Factory Default Settings
To reset the HAI UPB™ Lumina Mode Controller to factory default settings:
Step Operation
1 Press and hold the “AWAY” and “HOME” pushbuttons simultaneously for at least 3 seconds.
2 All of the LED indicators will blink to indicate that the HAI UPB™ Lumina Mode Controller is in Setup Mode.
3 Press and hold the “SLEEP” and “PARTY” pushbuttons simultaneously for at least 3 seconds.
4 The LED indicators will stop blinking and the “SLEEP” and “PARTY” pushbuttons will illuminate to indicate that it has
been reset.
SPECIFICATIONS
Model Number 38A00-3
Number of Backlit Pushbuttons with LED Indicators 6
Connections 18 GA
Dimensions 4.1 x 1.7 x 1.5
Weight 0.25 lb.
Mounting Standard J Box
Input Power 120 ± 12 VAC
Input Frequency 60 ± 3 Hz
Operating Temperature -40 °F to 104 °F
Note: It is normal for this switch to make a slight buzzing sound during operation.
LIMITED WARRANTY
HAI warrants this product against defects in material and workmanship, under normal use and service, for a period of two (2) years from the date of
purchase. During the warranty period, HAI will repair or replace, at its sole option, if this product fails due to defect. This warranty does not cover the
cost of removal or reinstallation of any product. This warranty does not cover failure caused by normal wear, damage to the product while in
your possession (other than damage caused by defect or malfunction), or by its improper installation, including failure to follow the written
installation and operation instructions, alterations, misuse, or abuse. The remedies provided for in this warranty are the sole and exclusive
remedies thereof. In no event shall HAI be liable for incidental expenses or consequential loss or damages. For the complete HAI Warranty for USA
policy, see the HAI web site at www.homeauto.com.
Any implied warranties, including warranties of merchantability and fitness for particular use or purpose are limited to a period of two (2)
years from purchase date. This warranty gives you specific legal rights, and you may have other legal rights, which vary from state to state. Some
limitations may not apply to you.
For warranty and repair service within the continental United States, send defective unit carefully packaged, postage prepaid, along with description of
trouble, name, return address, and phone number to: HAI, Repair Department, 4330 Michoud Blvd, New Orleans, LA, 70129. HAI will pay return
shipping charges via normal ground service.
Outside of the continental United States: Contact an Authorized Distributor for repair/replacement instructions.