Filter
Top Products
6
Place a large washer (1) over mounting screw, and then in-
sert screw through grid at marked location. (Fig. 8)
Lift the projector mounting plate and place a second large
washer (1) onto the end of the screw, followed by a metal
spacer (2). Loosely thread (2-3 turns) screw assembly into
the chosen threaded insert on the bottom of the projector.
(Fig. 9)
Repeat this procedure for the remaining threaded inserts.
(Fig. 10)
Note: A 1” plastic spacer (3) is included for projectors with
uneven mounting surfaces. Trim the plastic spacer to the
required length, and install on appropriate mounting screw.
Fig. 8
Fig. 9
Fig. 10
Once all mounting screws have been installed, square up the projector mounting plate,
and then tighten the mounting screws securely.
Caution: Do not force or over tighten the mounting screws, or damage to the projector
may occur.
Step 5
Slide the bottom projector mounting plate onto
the previously installed top projector mounting
plate. (Fig. 11)
Note: Make sure that the cables don’t get
pinched while sliding the plates together.
Fig. 11
3
Part Projector Mounting Hard-
ware
Qty. Bag
1 Large Washer 8 (a)
2 Metal Spacer: 3/8” 4 (a)
3 Plastic Spacer: 1” 1 (b)
PMD-1 PMD-2
4 Screw:
5mm x 25mm
Screw:
6mm x 25mm
4 (c)
5 Screw:
4mm x 25mm
Screw:
5mm x 25mm
4 (c)
6 Screw:
3mm x 25mm
Screw:
4mm x 25mm
4 (c)
Step 1
With an electronic stud finder, locate center of ceiling stud in desired mounting loca-
tion. Unscrew ceiling plate (E) from Projector Mounting top plate (A). Use ceiling plate
as a template, and mark mounting hole locations. Drill mounting holes to a depth of 3”
using a 3/16” drill bit. Mount ceiling plate to stud with 5/16” lag bolts (J).
Hardware Bags
Extended Ceiling Mount
For installations that require a ceiling drop
in excess of 18”, standard 1 ½” pipe may be
used to extend the standard pipe drop as-
sembly.
Pipe extension should be cut to the required
additional length, threaded on both ends,
and then attached to the standard pipe drop
assembly with a pipe coupler (not supplied).
Note: Orient the cable management port
on the pipe drop assembly so that it faces
the projector cable drop.
Standard Ceiling Mount
Press plastic cover (D) into place over ceiling plate.
Attach pipe drop assembly (C) to ceiling plate with three 5/8”
hex screws (H).
Note: Orient the cable management port on the pipe drop
assembly so that it faces the projector cable drop.
Step 2
Determine type of installation:
• Standard Ceiling Mount
• Extended Ceiling Mount
• Flush Mount
• Wall Mount