Filter
Top Products
2 - 3
Using the Quick*View Software
Upon startup, the Quick*View splash screen appears for approximately three
seconds. Quick*View will then attempt to establish communications with the
Imager.
If Communication Cannot Be Established
This message appears if communication cannot be established:
Quick*View defaults to com 1 as the communications port. If you have plugged
the Imager into another com port, you must Cancel out of this message.
Click on File - Preferences. This popup appears:
Click on the
radio button for
the appropriate
com port, then
click on OK.
Quick*View
should now be
able to locate
the Imager.
You may also need to pull the Imager’s trigger to establish communications
between the PC and the Imager.
If you want Quick*View to search for the Imager and establish communication,
click on Device - Auto Baud Detect.