Filter
Top Products
2 - 1
2
Terminal Interfaces
Terminal ID
If your interface is not covered by a Plug and Play barcode from Chapter 1, then
refer to Supported Terminals on page 2-2 through page 2-3, and locate the Ter-
minal ID number for your PC. Scan the
Terminal ID
barcode below, then scan
the numeric barcode(s) from the Programming Chart inside the back cover of
this manual to program the imager for your terminal ID. Scan
Save
to save your
selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID
barcode, then
0, 0, 3
from the Programming Chart inside the back
cover of this manual, then
Save
. If you make an error while scanning the digits
(before scanning Save), scan the
Discard
code on the Programming Chart,
scan the
Terminal ID
barcode, scan the digits, and the
Save
code again.
Note: After scanning one of these codes, you must power cycle your computer.
Terminal ID
Save