Filter
Top Products
4600rp, 4600g/4600r, 4800i User’s Guide 3 - 3
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same
number of beeps will be applied to the beeper and LED in response to a good
read. For example, if you program this option to have five beeps, there will be
five beeps and five LED flashes in response to a good read. The beeps and LED
flashes are in sync with one another. To change the number of beeps, scan the
barcodebarcode below and then scan a digit (1-9) barcode and the
Save
barcode on the Programming Chart inside the back cover of this manual.
Default
= One.
Good Read Delay
This sets the minimum amount of time before the imager can read another
barcode.
Default = No Delay.
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the barcode
below, then set the delay (from 0-30,000 milliseconds) by scanning digits from
the inside back cover, then scanning
Save
.
Number of Pulses
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay