Filter
Top Products
4600rp, 4600g/4600r, 4800i User’s Guide 3 - 9
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the barcode below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the inside
back cover, then scanning
Save
.
LED Power Level
This selection allows you to adjust LED and aimer brightness.
Off
is used when
no illumination is needed.
Low
is used if low illumination is sufficient.
High
(the
default) is the brightest setting.
If you have an aimer delay programmed (see Aimer Delay on page 3-10), the
aimer will be at 100% power during the delay, regardless of the LED Power
Level.
Note: If you scan the Off barcode, both the aimer and illumination lights turn off,
making it impossible to scan barcodes in low light. To turn the LED Power
Level back on, move to a brightly lit area and scan either the Low or the
High barcode below.
Illumination Lights
If you want the illumination lights on while reading a barcode, scan the Lights On
barcode, below. However, if you want to turn just the lights off, scan the Lights
Off barcode.
User-Specified Reread Delay
Off
Low (50%)
* High (100%)