Filter
Top Products
ii
Wand Emulation ................................................................. 2-14
Data Block Size............................................................ 2-14
Delay Between Blocks ................................................. 2-14
Overall Checksum........................................................ 2-15
Wand Emulation Transmission Rate............................ 2-15
Wand Emulation Polarity............................................. 2-16
Wand Emulation Idle ................................................... 2-16
Chapter 3 - Output
Good Read Indicators ........................................................... 3-1
Beeper – Good Read ...................................................... 3-1
Beeper Volume – Good Read ........................................ 3-1
Beeper Pitch – Good Read ............................................. 3-2
Beeper Duration – Good Read ....................................... 3-2
LED – Good Read.......................................................... 3-2
Number of Beeps – Good Read ..................................... 3-3
Good Read Delay.................................................................. 3-3
User-Specified Good Read Delay......................................... 3-3
Trigger Modes ...................................................................... 3-4
Manual/Serial Trigger .................................................... 3-4
In-Stand Sensor Mode (4600r only) ..................................... 3-5
Scan Stand Mode .................................................................. 3-5
Scan Stand Symbol ........................................................ 3-6
Presentation Mode ................................................................ 3-6
Presentation LED Behavior after Decode...................... 3-7
Presentation Sensitivity.................................................. 3-7
Streaming Presentation™ Mode........................................... 3-7
Hands Free Time-Out ........................................................... 3-8
Reread Delay ........................................................................ 3-8
User-Specified Reread Delay ............................................... 3-9
LED Power Level ................................................................. 3-9
Illumination Lights ............................................................... 3-9
Imager Time-Out ................................................................ 3-10
Aimer Delay........................................................................ 3-10
User-Specified Aimer Delay........................................ 3-11
Aimer Mode........................................................................ 3-11