Filter
Top Products
4 Dolphin® 9500 Series Mobile Computer Quick Start Guide
Setting Up Dolphin 9500 Series Terminals
1. Unpack the carton and verify its contents - page 4.
2. Install the battery in the terminal - page 4.
3. Charge the main battery in the terminal for a minimum of four hours - page 4.
4. Initialize the terminal - page 5.
Step 1: Install the Main Battery Pack
Use only the Li-ion battery packs provided by
Hand Held Products
. The use of any
battery pack not sold/manufactured by
Hand Held Products
in the Dolphin 9500 Series
terminal will void your warranty and may result in damage to the Dolphin terminal or
battery.
Remove the Dolphin 9500/9501 Hand Strap
Dolphin 9500/9501 terminals ship with the
hand strap installed and fastened with a clip on
the bottom panel.
Push the clip of the hand strap down and away
from the terminal. Move the strap up and away
from the bottom panel.
To re-attach the hand strap, slide the clip back
into place on the bottom panel.
Install the Battery
1. Remove the Li-ion battery pack from its
package.
2. Hold the terminal with the front panel
(keyboard) facing down.
3. If necessary, detach the hand strap.
4. Take the battery and insert the end without
the locking tab into the top of the battery
well and push down with a hinging motion
until the locking tab snaps.
5. If necessary, re-attach the hand strap.
To remove the battery pack, detach the hand
strap, press the locking tab on the battery pack away from the bottom panel, and
pull the battery pack up with a hinging motion.
Step 2: Charge the Main and Backup Batteries
The power supply consists of two types of battery power: the main battery pack
installed in the back panel and the backup battery located inside the terminal.
The main battery powers the terminal and charges the internal backup battery.
The internal backup battery maintains the data stored in RAM memory and the
keeps the system clock running for up to 30 minutes when the main battery is
completely discharged or removed.
!
Clip
Hand Strap