Harbor Freight Tools 92499 Laminator User Manual


 
SKU 92499 For technical questions, please call 1-800-444-3353 PAGE 10
6. Make sure the
sealed
edge of the laminating film is inserted first into the
Laminator to avoid jamming. Keep hands and fingers clear of the Adjustable
Front Guide (6).
7. Once inserted into the Laminator, the laminating object will be automatically
drawn into the Laminator and ejected from the Rear Guide Platform (7). To
avoid possible accidental burns, make sure to wear safety gloves (not
included) when first removing the laminating object from the Rear Guide
Platform. (See Assy. Diagram.)
8. When finished laminating, turn the Power Switch (1) to its “OFF” position and
unplug the Laminator from its electrical outlet. Allow the Laminator to completely
cool. Then store the unit in a dry, dust free location out of reach of children.
(See Figure D.)
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Power Switch (1) of the Laminator is in its
“OFF” position, the Power Cord (2) is unplugged from its electrical outlet, and
the unit has completely cooled before performing any inspection, maintenance,
or cleaning procedures.
2. Before each use: Inspect the general condition of the Laminator. Check for
misalignment or binding of moving parts, damaged electrical wiring, cracked or
broken parts, and any other condition that may affect its safe operation. If abnor-
mal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3. To clean: Use a clean cloth and a mild detergent. Do not use solvents. Do not
immersed any part of the Laminator in liquids.
4. All maintenance, service, and repairs not listed in this manual are only to
be attempted by a qualified technician.
5. Place the object to be laminated (i.e., paper, card, etc.) between the two layers of
laminating film, and center the object on the laminating film.