Harbor Freight Tools 92499 Laminator User Manual


 
SKU 92499 For technical questions, please call 1-800-444-3353 PAGE 9
OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 11.
1. Extend the two Pull Out Rear Platforms (6). (See Figure D.)
2. Plug the Power Cord (2) into the nearest 110 volt, grounded, electrical outlet.
(See Figure D.)
4. IMPORTANT: Prior to laminating, always allow 7 to 8 minutes for the Laminator
to warm up
and
wait until the Green LED Light (4) illuminates, indicating the
Laminator is “READY” to use. (See Figure D.)
POWER SWITCH
(1)
POWER CORD (2) RED
LED LIGHT
(3)
GREEN
LED LIGHT
(4)
FRONT PLATFORM
(5)
PULL OUT REAR PLATFORM
(6)
FIGURE D
3. Turn the Power Switch (1) to its “ON” position. NOTE: The Red LED light (3)
will illuminate, indicating that the electrical power is on. Also, the internal rollers
will begin turning. (See Figure D.)