Filter
Top Products
Configuration
3-2 HP Uninterruptible Power System R1500 XR Models User Guide
2. Press and hold the Configure button (1) for three seconds. When the Configure button is
released, the front panel configuration parameters flash in unison and the Configure
Mode On LED (2) illuminates solid green.
1 2
Figure 3-2: Placing the UPS in Configure mode
Configuration Parameters
In Configure mode, the front panel LED display changes function to allow UPS monitoring.
The LED control buttons allow modification of the UPS configuration parameters. The
configuration parameters are defined in Table 3-1. Available voltage settings per model are
listed in Table 3-2.
Table 3-1: Configuration Parameters
Parameter (LED) Parameter Name Explanation (when illuminated)
General Alarm
(
)
100 Nom*
Nominal utility voltage level is selected to 100 VAC.
On Battery
(
)
110/220 Nom
Nominal utility voltage level is selected to 110/220 VAC.
Bad Battery/Low
Battery
(
)
120/230 Nom
Nominal utility voltage level is selected to 120/230 VAC.
Site Wiring Fault
Indicator
(
)
127/240 Nom
Nominal utility voltage level is selected to 127/240 VAC.
Utility LED
(
)
Site Wiring
Fault Indicator
Audible alarm is enabled if ground is missing, or if line
and neutral connections are reversed.
*The 200/208 parameter is printed on the front panel for future enhancement purposes.