Filter
Top Products
IMPORTANT: The DHCP server assigns the IP address to the iLO NIC. The DHCP
server is not necessary if you have configured iLO and/or any other connected NICs to
use a static IP address.
To connect with the network cabling method:
1. Follow steps 1 through 7 of “Using the Direct Cabling Method with a Client PC”
to make the connections from the server blade to the diagnostic station.
WARNING: To avoid electric shock, be sure that the AC power is disconnected
from the diagnostic station when connecting cables to the server blade.
2. Connect the network cable with RJ-45 connectors to the diagnostic station NIC 4
connector (1) and to the hub (2).
3. Connect the AC power cord to the diagnostic station (3).
NOTE: Previously installed components have been removed for clarity.
Depending on which server blade you are using, you may need to install a second power
supply in the diagnostic station. A second power cord would also be required.
Figure 15: Connecting a network cable and the AC
power cord to the diagnostic station
HP ProLiant BL p-Class System Diagnostic Station User Guide 27