Filter
Top Products
3.3 Auto Layout 29
Area Determine
Methods for obtaining the effective coordinate area based on the HP-GL data are as
follows:
[Auto]
An effective coordinate area determining method is automatically selected among PS, IW,
IP, Adapted. PS, IW, IP, Adapted are given priority in this order.
[IW]
The area specified by the last IW command in data is determined as the effective coordinate
area. If data contains no IW command, Adapted is used to determine the effective
coordinate area.
[IP]
The area containing the area specified by all IP commands in data is determined as the
effective coordinate area. If data contains no IW command, Adapted is used to determine
the effective coordinate area.
[Adapted]
The effective coordinate area is determined by the following conditions:
• Maximum and minimum position coordinates of the points plotted by drawing commands
• Maximum character size in the page
• Maximum pen width
[PS]
The area containing the area specified by the first PS command in data is determined as
the effective coordinate area. If data contains no PS command, Adapted is used to
determine the effective coordinate area.
Paper Margin
Specify the paper margin within the range between 0 mm (0.0") and 99 mm (3.9"). The
default is [0 mm] ([0.0"]). The area obtained by removing the area specified by making the
[Paper Margin] setting from the effective coordinate area obtained in [Area Determine] is
determined as the effective coordinate area.
Area obtained in [Area Determine]
Area obtained by removing the area specified by making the [Paper Margin] setting from the
effective coordinate area obtained in [Area Determine]
Paper margin
The image exceeding the bounds of
the hard clip area is not plotted.