Filter
Top Products
34 3 Materials Related to HP-GL Mode
When [Document Size] Is Set to [Auto] and [Zoom Mode] Is Set to
[Coordinate Area]
The [Hard Clip] setting becomes ineffective. The extended hard clip area is always used.
The scaling factor is determined by the effective coordinate area and output size.
The following table summarizes effective coordinate areas by paper size.
Note
• Some output sizes may not be used depending on the printer type.
Unit: Plotter unit
The maximum scaling factor is equivalent to 210% of the size of the extended hard clip area
of each paper and the minimum scaling factor is equivalent to 22.5%.
Limits During Auto Layout Mapping
When the Hard Disk (Optional) Is Installed in the Printer
Print data is stored to the hard disk when Auto Layout is executed.
When the Hard Disk (Optional) Is Not Installed in the Printer
Print data is stored to the Auto Layout memory when Auto Layout is executed. The initial
capacity of the Auto Layout memory is 64 KB. Therefore, this printer cannot correctly output
auto layout if the print data received by the auto layout memory exceeds 64 KB. In this case,
change the size of the Auto Layout memory from the printer control panel. The upper limit
of the Auto Layout memory is 5,120 KB. The auto layout memory cannot accept data larger
than 5,120 KB.
We recommend installing the hard disk to this printer if you are going to use the auto layout
function.
Output
size
0 degree 90 degrees
Minimum value Maximum value Minimum value Maximum value
P2x-P1x P2y-P1y P2x-P1x P2y-P1y P2x-P1x P2y-P1y P2x-P1x P2y-P1y
A3 7829 5485 73075 51200 5485 7829 51200 73075
A4 5485 3828 51200 35733 3828 5485 35733 51200
A5 3828 2648 35733 24720 2648 3828 44088 35733
B4 6762 4723 63120 44088 4723 6762 44088 63120
B5 4723 3297 44088 30773 3297 4723 30773 44088