Filter
Top Products
2-22
Installation and Configuration
Loading Paper in the Input (Paper) Tray
SL3
SL28
12
34
Check the position of the paper size setting
and adjust if necessary.
Slide the green paper guide until it snaps into
place at the appropriate paper size setting.
Note: Only letter-, legal-, and A4-size paper
can be loaded for fax reception and copying.
Paper Guide
Pull the input tray out until it is fully extended.
Load the paper (print side down), aligning the
right edge of the paper to the right side of the
tray. The paper stack should fit underneath the
grip on the input tray handle.
Up to 100 sheets (about 1 cm. or 1/2-inch thick
stack) can be loaded into the tray.
Input Tray Handle Grip
Helpful Hints:
Do not force the input tray all the way in when
closing it. The paper must not buckle or a paper
jam could occur.
This table lists the allowable paper sizes.
Description
Letter
A4
1
Legal
Size
8.5 x 11 inches (216 x 279 mm)
8.27 x 11.7 inches (210 x 297 mm)
8.5 x 14 inches (216 x 356 mm)
A4 is the standard size for letters in European countries.
Executive
2
7.25 x 10.5 inches (184 x 267 mm)
The user cannot make copies or receive faxes on this paper
size.
Be sure to set the paper size in the menu.
SL2
Remove the tray bridge by lifting it up and
off of the handle grip..
Tray Bridge
Install the tray bridge by pressing it down
onto the handle grip.
The tray bridge lifts printed faxes and pages
above the paper tray handle to prevent them
from becoming jammed inside the machine.
(The tray bridge must be used when receiving
faxes to legal-size paper or when printing on
glossy paper or HP Premium Transparency
Film.)
1
2