Filter
Top Products
1. Open the scanner lid.
2. Remove the negative strip holder, if present, from the slide holder.
3. Place the slides into the slide holder. Insert the slides with the top of the slides
pointing up and with the front of the slides facing you.
4. Close the scanner lid.
Note Make sure that the slides are flat and do not overlap. Do not press
the Scan button until the slides are loaded and the lid is closed.
5. Press the Scan (
) button on the scanner, or click Scan Film in the HP
Solution Center.
6. In the HP Scanning dialog box, select Picture.
7. Select Scan positives, including 35 mm slides, using the TMA.
If you want to preview the scanned image, select the Show Preview check box
on the screen, or begin the scan from the HP Solution Center.
8. Click Scan.
9. Follow the instructions on the screen to finish scanning.
The scan is sent to the destination selected in the HP Scanning dialog box.
10. When finished, remove the slides. Place the negative strip holder back into the
scanner lid for convenient storage.
Scan negatives
To scan 35 mm negatives, use the negative strip holder. The negative strip holder is
stored within the slide holder that is part of the built-in transparent materials adapter
(TMA).
Note You must use the negative strip holder to scan 35 mm negatives.
Always return the negative strip holder to its storage place inside the slide
holder in the scanner lid when done.
User's Manual 7
HP All-in-One Information Engineering