Filter
Top Products
1. Open the scanner lid and remove the negative strip holder from the slide holder.
2. Slide a negative strip into the negative strip holder as indicated by the icons on
the holder.
Note Negatives are easily damaged. Touch them only on their edges.
Use the blank to fill in any unused spaces in the holder.
3. Insert the negative strip holder back into the slide holder, and then close the
scanner lid.
4. Press the Scan button (
) on the scanner, or click Scan Film in the HP
Solution Center.
5. Select Picture.
6. Select Scan negatives using the Transparent Materials Adapter (TMA).
If you want to preview the scanned image, select the Show Preview check box
on the screen, or begin the scan from the HP Solution Center.
7. Click Scan.
8. Follow the instructions on the screen to finish scanning.
The scan is sent to the destination selected in the HP Scanning dialog box.
9. When finished, remove the negative strip. Place the negative strip holder back
into the scanner lid for convenient storage.
Tips for scanning transparent items
● To scan items larger than those that the transparent materials adapter (TMA)
accepts, place the transparency on the scanner glass, place a white sheet of
paper on top of the transparency, and then scan as usual.
● When scanning a 35 mm slide or negative, the scanner software automatically
enlarges the image to approximately 10 cm x 15 cm (4 x 6 inches). If you want
the final image to be larger or smaller, use the Resize tool in the scanner
Chapter 1
8 HP Scanjet 3800
HP All-in-One Information Engineering