Filter
Top Products
3 Connecting to a Windows NT Server 3.51
Windows NT Workstation Version 3.51
Windows NT
Workstation
Version 3.51
Requirements
• HP Vectra VE7/VE8 with Microsoft Windows NT Workstation 3.51 in-
stalled.
• 3COM 3C339 card and drivers disk
• Microsoft Windows NT Workstation 3.51 and Service Pack Media.
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• I/O Base Address DC00
• Interrupt Request Level 10
• Boot PROM Disabled
• Transceiver Type Auto Select
• Network Driver Optimization Windows or OS/2 Client
• Maximum Modem Speed 9600 Bps
• Plug and Play Compatibility Disabled
• Full Duplex Disabled
Procedure
1 With the HP Vectra VE7/VE8 turned off, install the 3COM Token Ring
3C339 adapter card into an PCI slot.
2 Connect network cable media to the 3COM 3C339 card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Software “3C339 drivers disk” and execute
“A:\3C3X9CFG.EXE.”
5 Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the 3COM software driver diskette and reboot the machine.
8 After Windows loads, open the “Main” program group, double-click on
“Control Panel” icon.