Filter
Top Products
12 Installing the 3COM Etherlink III 3C590 PCI 10BT Network Adapter
Microsoft Windows for Workgroups 3.11
12 Installing the 3COM Etherlink III 3C590 PCI 10BT
Network Adapter
Microsoft Windows for
Workgroups 3.11
Connecting to a
Windows NT 4.0 Server
Requirements
• HP Vectra with MS-DOS and MS-Windows for Workgroups 3.11
• 3COM Etherlink III 3C590 PCI 10BT network adapter and driver disk ver-
sion 5.2.2.
• Driver File: EL59X.386, version 1.18
• Microsoft Windows for Workgroups 3.11 media.
• Microsoft Windows NT 4.0 Server system that supports NetBEUI, NWLink
IPX/SPX Compatible Transport and NWLink NetBIOS network protocols.
• Device Configuration
Procedure
1 With the HP Vectra turned off, install the 3COM 3C590 network adapter
into a PCI slot.
2 Connect network cable media to the 3COM 3C590 network adapter.
3 After Windows loads, open the “NETWORK” Program Group, and double-
click on “Network Setup”.
4 Click on the “Networks” button in the “Network Setup” dialog box.
5 Click on the “Install Microsoft Windows Network:” option, and click “OK”.
6 Click on the “Drivers” button from the “Network Setup” dialog box, and
click on “Add Adapter”.
7 Click “OK” to accept the default choice of “Unlisted or Updated Network
Adapter”.
8 Type the path “A:\NDIS\WFW” in the “Install Driver” dialog box, and then
insert the 3COM 3C590 driver disk into the floppy drive, and click “OK”.
Device Configuration Vectra Vli8 Vectra VEi7 Vectra VEi8
Interrupt 05 05 05
I/O Address 300 300 300