Filter
Top Products
4 Connecting to a Windows NT Server 4.0
Windows 95 SR2
Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2.
• 3COM Etherlink 3C509-B Ethernet card and drivers disk ver 5.0.
Driver Name: Elnk3.Vxd Size: 30.2KB Date: 7/18/96
• DOS and MS-Windows for Workgroups 3.11 media.
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• I/O Base Address 300
• Interrupt Request Level 10
• Boot PROM Disabled
• Transceiver Type Auto Select
• Network Driver Optimization Windows or OS/2 Client
• Maximum Modem Speed 9600 Baud
• Plug and Play Compatibility Disabled
• Full Duplex Disabled
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B
adapter card into an ISA slot.
2 Connect network cable media to the 3COM 3C509B card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM drivers disk “Etherlink 3C509-B Ethernet
Drivers Ver. 5.0.” and change to Drive A: , and execute “3C5X9CFG.EXE.”
5 Select “Configure NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the 3Com Software driver diskette and reboot the machine.
8 Click on “Start” and point to “Settings”, then select the “Control Panel.”
9 In the Control Panel group, double click on the “Network” icon .