Filter
Top Products
IU 678 / 0225 7 TowerFeed
TM
for the HP Color LaserJet 4550
INSTALLATION
Hardware Installation
Warning:
POWER OFF your printer and TowerFeed and disconnect all power and interface cables before you
proceed with the installation.
Remove Transportation Inserts
• Pull out, lift upwards and remove the trays from TowerFeed.
Remove the transportation inserts (Fig. 8). There are two at
each side (keep the inserts for reshipment).
• Re-insert and close the trays.
Note:
Located on the right side of each tray you will find coding
pins for the paper size. They are set by the factory and must
not be changed.
Position and Connect Printer
Warning:
The printer may weigh up to 50 kilograms (115 pounds). Enlist the
help of a second person to lift the unit. To prevent back strain or
injury, bend your knees when lifting the unit.
Place the TowerFeed unit at the location you wish. Be sure to
place it on a flat location.
• Carefully lift the laser printer onto TowerFeed. Place its
positioning holes on the positioning pegs of the TowerFeed top
(Fig. 9).
Warning:
To lift the printer use the hand holds on the side of the printer.
Never reach with the fingers underneath the printer to avoid
injuries.
Fig. 8 Removing Transportation Inserts
Fig. 9 Positioning the printer and
location of the Power Switch