Filter
Top Products
10-12
Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Figure 10-6. Example of the Custom show interfaces Command
You can specify the column width by entering a colon after the column name,
then indicating the number of characters to display. In Figure 10-6 the Name
column only displays the first four characters of the name. All remaining
characters are truncated.
Note Each field has an fixed minimum width to be displayed. If you specify a field
width smaller than the minimum width, the information is displayed at the
minimum width. For example, if the minimum width for the Name field is 4
characters and you specify Name:2, the Name field displays 4 characters.
Parameters can be entered in any order. There is a limit of 80 characters per
line; if you exceed this limit an error displays.
Error Messages
ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed
enabled mdi
Status and Counters - Custom Port Status
Intrusion
Port Name Type VLAN Alert Speed Enabled MDI-mode
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco 100/1000T 1 No 1000FDx Yes Auto
2 Huma 100/1000T 1 No 1000FDx Yes Auto
3 Deve 100/1000T 1 No 1000FDx Yes Auto
4 Lab1 100/1000T 1 No 1000FDx Yes Auto
Error Error Message
Requesting too many fields (total characters
exceeds 80)
Total length of selected data exceeds one line
Field name is misspelled Invalid input: <input>
Mistake in specifying the port list Module not present for port or invalid port:
<input>
The port list is not specified Incomplete input: custom