Filter
Top Products
13-70
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Figure 13-18. Example of Displaying the Global and Per-Port Information Available for Outbound
Advertisements
Figure 13-19. Example of the Default Per-Port Information Content for Ports 1 and 2
Displaying the Current Port Speed and Duplex Configuration on a
Switch Port. Port speed and duplex information for a switch port and a
connected LLDP-MED endpoint can be compared for configuration
mismatches by using an SNMP application. You can also use the switch CLI
to display this information, if necessary. The following two commands provide
methods for displaying speed and duplex information for switch ports. For
information on displaying the currently configured port speed and duplex on
ProCurve# show lldp info local-device
LLDP Local Device Information
Chassis Type : mac-address
Chassis Id : 00 24 81 b0 09 21
System Name : ProCurve 6120 Blade Switch
System Description : ProCurve 498358-B21 6120 Blade Switch, revision ...
System Capabilities Supported:bridge
System Capabilities Enabled:bridge
Management Address :
Type:ipv4
Address:16.93.40.251
LLDP Port Information
Port | PortType PortId PortDesc
-------- + -------- -------- --------
D1 | local 1 D1
D2 | local 2 D2
D3 | local 3 D3
D4 | local 4 D4
D5 | local 5 D5
D6 | local 6 D6
. . . .
. . . .
. . . .
The Management Address field displays only
the LLDP-configurable IP addresses on the
switch. (Only manually-configured IP
addresses are LLDP-configurable.) If the
switch has only an IP address from a DHCP or
Bootp server, then the Management Address
field is empty (because there are no LLDP-
configurable IP addresses available). For more
on this topic, refer to “Remote Management
Address” on page 13-42.